Broken Kel Tec P32

Some readers of this blog might own a Kel Tec P32. The trigger looks like its double action only, but not really. If the user has the gun empty with the slide forward, the trigger can be pulled. When pulled, the trigger causes the hammer to move from its resting place. The hammer moves rearward, then (should) go forward to the firing pin. After the hammer goes to the firing pin, it stays there until the hammer is reset by moving the slide. When the slide resets the hammer, the trigger can be pulled again to actuate the hammer.

Right now, the hammer does not go far enough forward to touch the firing pin. The trigger can be pulled multiple times and every time it resets itself without having to pull back on the slide. The trigger will occasionally actuate the hammer in the proper fashion, but to get the gun to do this, I have to pull the trigger very slowly while pulling toward the left or right. Something in the linkage is probably broken. It needs to go in for service.

Now I'm not so glad I Duracoated the gun. When it goes back, there's a chance that I might get a brand new 2nd generation P32 in return. I've read online of that happening a lot when 1st gen guns are worn or 1st gen parts are broken that Kel Tec no longer stocks. Apparently Kel Tec will put your serial number on a brand new P32 and send that to you. If they do that, I'm not getting back the slide I just worked on. Oh well.

Jennings J22 Duracoat Refinishing

I got a Jennings J22 for cheap. The finish on the frame wasn't great, but the slide was perfect. After helping a friend assemble his blasting cabinet, I stripped the Jennings' frame and sandblasted it in preparation for Duracoat.

The media we used was black and very fine. That's all I can tell you about it. My friend picked it up at Grainger, an industrial supply company. We used a #4 tip on the Harbor Freight blasting cabinet with 40 to 60 pounds of pressure.

I should've taken the barrel off of the frame to begin with. I definitely hit the outside of the barrel with the sandblaster, which meant I needed to remove it anyway to polish out the roughness. With the barrel removed, I was better able to sandblast all portions of the frame.

I shot the frame with Snow Gray Duracoat. I used my friend's Badger airbrush. The airbrush took forever to spray the paint and got clogged halfway through. The finish went on very thin. I reassembled the gun (aside from the one missing pin that I lost in my friend's shop) and took a photo. I like the look.

I really think I may be the first person in the history of the internet to duracoat a Jennings. This is history folks, history.

Henry Mare's Leg Pistol

In old Western movies, people sometimes had cut down lever action guns. I've never been a fan of that genre of movie, but I do like the guns. Rossi announced a few months ago that they were going to build a lever action with a short stock and short barrel, but build it from the ground up as a pistol. That's right folks, buy it like any other handgun. No NFA registration, no SBR paperwork, no tax stamp, and no engraving.

Building one of these from the ground up as a pistol was something I never thought of doing. Its a classic case of "Why didn't I think of that?".

Rossi isn't the only one jumping into this new handgun market. Henry has announced Mare's Leg style guns in 22LR and 45 Long Colt, also to be sold as handguns. I've got my eye on the rimfire Henry, which is basically a cut down Golden Boy. With an MSRP of $360, I hope to have one in my hands for under $300.